braille_xr

refreshable braille display for rendering and input with handtracking

[ disclaimer ]

this early repo may require special help/information depending on your setup and prior knowledge - so do not hesitate to reach out to @spatialfree with any questions!

init

required

c++ compiler (in PATH)
vscode
ctrl+alt+i to rebuild intellisense configuration
arduino extension
arduino esp32 includes [ WiFi, AsyncUDP ]
ESP32Servo (arduino library manager)
dotnet sdk v8

setup

enter your wifi credentials in hardware/braille_xr/_wifi_config.h --removing the leading underscore in the filename so it get's included in sketch (and gitignored)

# *on linux make sure you can r/w
sudo chmod 666 /dev/ttyUSB0

open the serial monitor and upload the sketch to your board
if successful after a series of connection codes it will print out the ip of your device and await input from the sk_demo
before running the demo with dotnet run please replace the ip value in sk_demo/src/MonoNet.cs with your boards ip address

currently the demo simply changes the displayed character as the tracked r_hand is moved along the x axis

hardware

6x 9g servos
esp32 board / with breakout pins+power for the servos
...

<3

Bryan Chris Brown

StereoNick

Peter Sassaman

Lucas De Bonet (LucidVR)

WIP hot glue bump tutorial

reset the device *press enter key and disconnect power
align where the bump will be with gravity and generally aim the glue gun opposite (pre-heating the screw head will help the glue flow)
get coverage starting from the top *wrapping the glue around the screw head (until it's just touching the threads)
end with the glue you need for the bump before lifting up and away to round it out
use the side of the nozzle to reshape as needed

2.2 KiB Raw Permalink Blame History